You can set the "Min Read Time" under the Control tab to a smaller number than the default(.07). Then the duration will decrease. Just like the picture shows:
Articles in this section
- Why Do Scan Results Differ Each Time?
- Is it ok to run BFB on scalar while terrain protocol is running on a separate generator?
- Can I perform other biofeedback scans in scalar field? Why can I do biofeedback scan using Scalar Digitizer?
- If the scalar hunt & kill program using the scalar digitizer is as effective as using the contact mode ?
- It takes longer time to do a scalar bfb scan using the newest software version. How can I shorten the time?
- How long does it take to do a biofeedback scan with scalar digitizer? Can I do the scan and use cold laser wrist at the same time?
- Can I make a scalar biofeedback scan with a XM generator?
- Can we treat 2 people (couple) between the Scalar? For example: performing a BFB Hut & Kill while sleeping?
- Can Spooky2 Scalar biofeedback scan support high end frequencies from 14MHz to 16MHz?
- Why it takes more than hours to do hunt and kill without stop?
Comments
Please sign in to leave a comment.