Spooky2
Articles
-
Can the results from a Scalar BFB session be applied to the body later only thru Scalar or could they also be run as a program for plasma?
Yes, you can run these results anywhere. One thing though, the Scalar only scans up to 50 kHz. For this reason, you might be better off doing a TENS pad scan. However, there are cases where a TENS ...
-
Can I run the program as contact if I do BFB with Scalar?
This is possible, but the scalar BFB scan only scans to 50 kHz. Ideally you treat yourself with the scalar for a scalar BFB Scan, but other modes like contact can work. But if you want a wider rang...
-
Does Scalar support beyond 50 khz while doing BFB scan?
There are no limitations for scalar with respect to the frequency range. The following article explains how the software adjusts the range by itself/you can also play with the settings if you know ...
-
Is there anyone who has had experience with using Spooky2 Scalar for bipolar disorder?
Being bipolar myself, and having married another with bipolar, I can comment at least this much… Scalar will probably not address it but can help, being that the root of the issue is usually a chem...
-
I have an in-ground swimming pool 18×36, will the water absorb the scalar energy and imprint the water in the pool if I set up the Scalar on either side, on the end where the inlet valve is?
No, it won’t, but anyone in the field would benefit from it. The best way to reset your water is to go to install a water filter, get from a hardware store, in the water line feeding pool and/or ho...
-
Can we use alcohol swabs to clean the transmitter and receiver coils?
Yes, you can use alcohol swabs with 70% alcohol for cleaning. For more details, please check this link:https://www.spooky2.com/forums/viewtopic.php?t=14804&sid=c6d3964841e1c1d147d5005006b68d93
-
Will earthing sheet interfere with the scalar field if I sleep on it?
No, it won’t interfere with the scalar field as long as the link cable does not touch the ground. For more details, please check this link:https://www.facebook.com/groups/spooky2scalar/posts/119784...
-
How can Spooky2 Scalar reach high frequencies (1,600,000hz) with 50,000hz frequency limits?
The software will find a subharmonic of the higher frequencies that will work in the Scalar range of < 50 KHz.Q: Can I put the silver coin on the coil to help the frequencies higher?A: That will no...
-
What is the Ohm value of the BNC wire to connect Scalar to GenX?
All Spooky2 gear run on 50 ohms. If for some reason you are forced to use 75 ohms, it will work without too much of a problem, as the distances are very short and the frequencies are so low, relati...
-
How long do you run the scalar when using medicines?
Normally it’s suggested to run Scalar for at least 1 hour during the day. If you put drugs on the receiver box, please pay attention and see if you have any discomfort. Drugs may have side effects ...