Spooky2
Articles
-
What is the Ohm value of the BNC wire to connect Scalar to GenX?
All Spooky2 gear run on 50 ohms. If for some reason you are forced to use 75 ohms, it will work without too much of a problem, as the distances are very short and the frequencies are so low, relati...
-
How can Spooky2 Scalar reach high frequencies (1,600,000hz) with 50,000hz frequency limits?
The software will find a subharmonic of the higher frequencies that will work in the Scalar range of < 50 KHz.Q: Can I put the silver coin on the coil to help the frequencies higher?A: That will no...
-
I have an in-ground swimming pool 18×36, will the water absorb the scalar energy and imprint the water in the pool if I set up the Scalar on either side, on the end where the inlet valve is?
No, it won’t, but anyone in the field would benefit from it. The best way to reset your water is to go to install a water filter, get from a hardware store, in the water line feeding pool and/or ho...
-
Does Scalar support beyond 50 khz while doing BFB scan?
There are no limitations for scalar with respect to the frequency range. The following article explains how the software adjusts the range by itself/you can also play with the settings if you know ...
-
Do I need to tune required if the receiver connection is needed to produce the field?
The tuning light on the transmitter only shows you that the transmitter coil is in resonance with the frequency enough to produce a sufficient magnetic field to light the LED. It doesn’t do anythin...
-
Welcome to your Help Center!
You're looking at your new Help Center. We populated it with placeholder content to help you get started. Feel free to edit or delete this content. The Help Center is designed to provide a complet...
-
What are these sections and articles doing here?
This FAQ is a section in the General category of your help center knowledge base. We created this category and a few common sections to help you get started with your Help Center. The knowledge ba...
-
How do I customize my Help Center?
You can modify the look and feel of your Help Center by changing colors and fonts. See Branding your Help Center to learn how. You can also change the design of your Help Center. If you're comfort...
-
How do I publish my content in other languages?
If you have configured your Help Center to support multiple languages, you can publish content in your supported languages. Here's the workflow for localizing your Help Center content into other ...
-
How can agents leverage knowledge to help customers?
You can use our Knowledge Capture app to leverage your team’s collective knowledge. Using the app, agents can: Search the Help Center without leaving the ticket Insert links to relevant Help C...