Spooky2
Articles
-
Do I need to stop Spooky2 Scalar when changing DNA samples in the scalar field? Will the supplements/essential oils be contaminated if used on the transmitter coil with many different DNA samples?
1. You shouldn’t need to shut down the field just to change samples. 2. At this point, if you’ve just been putting everything on the same coil, I’d start over with my samples. I’m not quite certain...
-
When they say Spooky2 Scalar “charges” the cells – do they mean it restores the proper voltage to the cells?
1. Yes, a person in good health has a charge of 70 to 100 millivolts. Aging, stress, poor diet or the environment can reduce this voltage. It has been found that a person with a cell voltage of 30 ...
-
Would using a microwave within the scalar field be a problem?
1. It should be ok, because microwave shielding will block the signal. But using microwave itself is never a good idea anyway. 2. Using a microwave anytime is a problem. It radiates out 3 feet from...
-
Does the scalar allow the Aleve to relieve pain if I can’t take this drug?
I think drugs in Scalar field may still have the side effect. If you can’t take this drug, I would certainly not suggest you put it on Scalar input coil. You could take some other drugs that could ...
-
How long does it take to print information into the water?
It only takes a few minutes to imprint information into a small container. A glass of water could take 10 minutes or more. A larger container would take even longer. If you want to learn more about...
-
Is it normal to not feel anything or hear anything when using Spooky2 Scalar?
1. Yes. Quite normal. 2. Make sure to tune the scalar device already. Also, on the receiver, if you press the button, the button should light up. Many people don’t feel the scalar energy in their ...
-
Should Scalar preset apply 5V, 100% offset and square waveform?
Yes. But the duty cycle can be anything. That’s the only difference.
-
One specification of Spooky2 Scalar is Scalar flow: 30mA. Is that current proportional to the strength of the Scalar Wave output? What is the voltage?
The current is proportional to the scalar field strength. It is AC. Current is through a wire. V = I * R. R = negligible. So volts = 0.
-
How to help lung function using Spooky2 Scalar?
Keeping a positive mental attitude is a must. And it’s important you clean up the diet and let go of the negative thoughts. Where I think you are lucky is you have the Spooky2 Scalar. You can plac...
-
How soon will you see any change after you start using Spooky2 Scalar?
1. That depends on the person, how sensitive they are to the energy and the condition one has. Some notice the energy right away. Some never feel it. As to seeing changes, I understand that scalar ...