It takes longer time to do a scalar bfb scan using the newest software version. How can I shorten the time?

Spooky2

Updated 3 months ago

You can set the "Min Read Time" under the Control tab to a smaller number than the default(.07). Then the duration will decrease. Just like the picture shows:

Comments

1 comment

Bernard Salles
3 months ago

Toujours pas compris !

0

Please sign in to leave a comment.

Articles in this section

For biofeedback scan setup, is it normal that the receiver’s red light doesn’t turn on when connected? Also, how can I set the scan to run only for an hour? It kept running beyond three hours last time.
What are the best ways to use scalar biofeedback results?When using the Hunt and Kill preset, do I need to run the biofeedback scan every time, or can I save the results for future use?
How long will the BFB take and how do you know when it is complete? Does it beep or somehow signal it is finished?
Why Do Scan Results Differ Each Time?
Is it ok to run BFB on scalar while terrain protocol is running on a separate generator?
Can I perform other biofeedback scans in scalar field? Why can I do biofeedback scan using Scalar Digitizer?
If the scalar hunt & kill program using the scalar digitizer is as effective as using the contact mode ?
It takes longer time to do a scalar bfb scan using the newest software version. How can I shorten the time?
How long does it take to do a biofeedback scan with scalar digitizer? Can I do the scan and use cold laser wrist at the same time?
Can I make a scalar biofeedback scan with a XM generator?

You can get support that’s tailored to you, owner exclusives and more

Our helpline hours:

8:00am - 8:00pm CST Monday to Friday; 9:00am - 6:00pm CST Saturday

Get the latest news and updates first