You can run the hits using any method, though scalar would be the best, as that was how the frequencies were applied.
What do you suggest for actually running the Scalar biofeedback results?
Not yet followed by anyone
Articles in this section
- For biofeedback scan setup, is it normal that the receiver’s red light doesn’t turn on when connected? Also, how can I set the scan to run only for an hour? It kept running beyond three hours last time.
- What are the best ways to use scalar biofeedback results?When using the Hunt and Kill preset, do I need to run the biofeedback scan every time, or can I save the results for future use?
- How long will the BFB take and how do you know when it is complete? Does it beep or somehow signal it is finished?
- Why Do Scan Results Differ Each Time?
- Is it ok to run BFB on scalar while terrain protocol is running on a separate generator?
- Can I perform other biofeedback scans in scalar field? Why can I do biofeedback scan using Scalar Digitizer?
- If the scalar hunt & kill program using the scalar digitizer is as effective as using the contact mode ?
- It takes longer time to do a scalar bfb scan using the newest software version. How can I shorten the time?
- How long does it take to do a biofeedback scan with scalar digitizer? Can I do the scan and use cold laser wrist at the same time?
- Can I make a scalar biofeedback scan with a XM generator?
Comments
Please sign in to leave a comment.