No. The carrier is only about 5.6 MHz, so modulation cannot be too high. If the modulation gets too high, it becomes itself a carrier. So the characteristics of the system change. I found during experiments and tests that 50,000 Hz was a good maximum. This is why it is in the presets. Of course, people are welcome to use higher modulation frequencies. I would say that at the very most, 1.7 MHz should be the maximum. Beyond that, the power to the coils will be markedly reduced.
Articles in this section
- Can I perform other biofeedback scans in scalar field? Why can I do biofeedback scan using Scalar Digitizer?
- If the scalar hunt & kill program using the scalar digitizer is as effective as using the contact mode ?
- It takes longer time to do a scalar bfb scan using the newest software version. How can I shorten the time?
- How long does it take to do a biofeedback scan with scalar digitizer? Can I do the scan and use cold laser wrist at the same time?
- Can I make a scalar biofeedback scan with a XM generator?
- Can we treat 2 people (couple) between the Scalar? For example: performing a BFB Hut & Kill while sleeping?
- Can Spooky2 Scalar biofeedback scan support high end frequencies from 14MHz to 16MHz?
- Why it takes more than hours to do hunt and kill without stop?
- Is grade scan good for finding healing frequencies or is it mostly used to search for frequencies killing pathogens?
- How long do I have to lie in the scalar field for the scan?
Comments
Please sign in to leave a comment.