Spooky2
Articles
-
Does the banana clip connection lead carry any voltage? If not, would it be possible to use UK house mains earth pin (3 pin plug), as the connection between the 2 cases? This would permit maximum distance between units within the building without a long t
You can not do that as the earth sinks the scalar signal.
-
What is the purpose of the link cable between the two Scalar boxes?
The link cable is single cable, not dual cable. It needs a complete circuit for the electrons to flow. The cable is sending power to the receiver, but not returning power. The returning path is the...
-
Can I plug the receiver ground wire into the whole house ground?
I would advise against it for two reasons: 1. If you connected the wrong wire you could get electrocuted. 2. You may introduce unwanted noise, power surges and smart power meter signals into Scalar...
-
If I use the long link cable, I get a reading of between 6.0-6.2 using tuning mothod 1 on the transmitter, but the light on the receiver is not illuminated.
Please do not roll the cables if the cable is long. it is very important. If it is rolled, the receiver light will not be up.
-
I tune Spooky2 Scalar correctly, then after an hour when I push the button on the receiver, it does not light up anymore. Then I tune it a bit clockwise and it lights up again on maximum. Then it stays tuned. I guess it has to do with the temperature that
It’s not a problem, I suggest everyone re-tunes their Scalar after about 1/2 hour when the environment and equipment stabilize. For more details, please check the link:https://www.facebook.com/grou...
-
If using crystals, essential oils, or other things on the Receiver coil, do you tune before or after placing them on the Receiver coil?
After tuning, you put the Substance on the Receiver coil. For more information, please check the link:https://www.facebook.com/groups/spooky2scalar/permalink/336129096960655/
-
Is there any protection for Spooky2 Scalar? Can a piece of metal (electrode) be put on the input coil to provide homeopathic input without damaging Scalar?
Spooky2 Scalar has protection. The metal won’t damage scalar. But you may have to retune it.
-
Do you use scalar remotely? Does it feel as strong as being in the Scalar field?
No, using the scalar set as a remote device feels as strong as using Spooky2Generator in remote mode. Being in the field feels much more intense. For more details, please check the link:https://www...
-
Can Scalar be used outdoor?
I will not because of humidity and dust as well as direct sun. Now if it’s just a matter of a couple of hours in a controlled situation why not. For more details, please check the link:https://www....
-
At my found tuning-frequency of 5.5 MHz using method1, the tuning light on my receiver is not lighting red at all. Is this still the perfect frequency, or should the red receiver light better glow up a little bit?
Yes, it is the perfect tuning. When it just lights up, turn about 2 clicks clockwise.