Is there a limit on the frequencies we can run through Spooky2 Scalar? Should we try to keep them under 50000 Hz since it’s the finish frequency of digitizer scan?

John White says in the Scalar Digitizer video that Spooky Scalar will modulate up to 5 Mhz, but there will be distortion.

Since the resonance frequency of the Scalar device is the usually 5-6 MHz, you will want the modulation frequency to be significantly lower than the resonance Frequency. The Scalar Digitizer biofeedback scan goes to 50 kHz, and the Scalar shell preset has a higher limit of 2MHz.

Doing a scalar scan is much more delicate of operation thus the lower frequencies for scanning, but for treatment, the rate can go higher.

For more details, please check the link from:
https://www.spooky2.com/forums/viewtopic.php?f=117&t=10586