How do I use Hydrogen in Scalar? It would reduce oxidative stress which is important in helping with liver and pulmonary failure.

1. If there was a way to get a drop or two of your blood mixed with Hydrogen and place it on the receive coil, I think you would see some good results. The trick would be mixing the two. I suppose you could wipe a drop of blood in a test tube, then invert it and flow Hydrogen gas up into it, seal it and let the magic happen. Or if you had slightly larger blood sample, bubble some gas through it.

I haven’t had that much experience with molecular weight frequencies on the scalar yet. Just placing a reagent, like Vitamin C on the coil isn’t as effective as mixing with blood.

I do run Schumann resonance frequencies and 8 Hz most of the time and it’s a noticeable difference. So maybe a MW signal would work okay.

2. I think these two topics may be helpful to you. Brad Rothman on his success using his blood and hydrogen water, or his blood and accelerated silver on the receiver plate of Spooky2 Scalar to put the information into the field:
https://www.spooky2.com/forums/viewtopic.php?f=117&t=10130

And Karl Becker’s molecular weight (MW) derived program for molecular hydrogen:
https://www.spooky2.com/forums/viewtopic.php?f=12&t=6781

You would not need the scalar device to run the program, just DNA in the remote. I would guess the scalar would be most effective if your patient is directly in the field between the two boxes with the mixture of blood and hydrogen water on the receiver plate.

For more details, please check the link from:
https://www.spooky2.com/forums/viewtopic.php?f=12&t=10387