If I use the long link cable, I get a reading of between 6.0-6.2 using tuning mothod 1 on the transmitter, but the light on the receiver is not illuminated.

Spooky2

2 years ago

Please do not roll the cables if the cable is long. it is very important. If it is rolled, the receiver light will not be up.

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

How can I test if Spooky2 Scalar is working?
What is the ideal tuning frequency?
If the button on the receiver was off during a bfb scan and during a rife treatment (but the transmitter had been tuned) does that mean nothing happened?
I find that the brightness of the tuning light on the Receiver is very sensitive to the lid angle.
Why can we still tune scalar when we don’t connect the transmitter and receiver with link cable?
I turn on Scalar, I turn the knob counter clockwise until the light is at it’s brightest. I’m at 5.6 then I turn the knob counter clockwise until the light goes off? I’m at 2.0 now? Is this correct?
What happens when Scalar is turned on and not tuned? Does it reset to 8.0 Mhz during a power outage? Is it pumping out dangerous levels of EMF radiation?
When should I worry about tuning point?
I used two different tuning methods, using method one produced 6.10MHz, using method two produced 5.65Mhz. How do I know which one is most accurate?
Can computers be in the Scalar field? Do you have to retune it at some point other than when you move it to a different position?

See more

Register your product

You can get support that’s tailored to you, owner exclusives and more

Our helpline hours:

8:00am - 8:00pm CST Monday to Friday; 9:00am - 6:00pm CST Saturday

Follow us on Twitter

Get the latest news and updates first