Why do we need a receiver when a transmitter can send out scalar Waves like Spooky2 Remote does and that can be received by the humans around it.

This may not be all encompassing or 100% entirely correct, but I’ll give it a shot.

The Spooky2 Remote creates two opposing waves — one from the top coil and one from the bottom coil which is in opposite phase to each other. These waves meet and cancel out, leaving behind a scalar field between the top and bottom of the remote. This information field is what the DNA sample picks up on; and using QE properties, shares the information in this field to the rest of the body.

The scalar wave does not travel, so it is confined to the inside of the remote. It is the QE aspects of DNA that allow that information to be benefited from anywhere you are located.

With the Spooky2 Scalar, a waveform is being used to energize the transmitter coil. This energy is being broadcast out. When it hits the receiver, it energizes the coil in kind, which will send back a reflecting wave.

When the frequency is tuned, the reflecting wave is 180 degrees out of phase, which interacts with the primary transmission. This leaves a scalar field between the two units.

Given that the boxes can be at various distances from each other when one sets them up, the frequency is adjusted to account for this to find the resonant point to create the standing wave that exists between them.

There are two points that this resonance can be achieved. One is a standard EMF field (lower frequency), the other is Scalar (higher frequency). With an oscilloscope, you can confirm visually which of the two you are generating.

EMF fields will have overlapping, in phase, waveforms. Scalar will have two that are nearly matching but 180 degrees apart. John shows this in the SAMA video here:

Since you can now sit in the scalar field, instead of just receiving an information field, you can receive the scalar energy directly along with whatever you modulate the field with (organic sample, frequency, etc.).

The only other way that I know that we can receive scalar energy directly by use of a Spooky2device, is via the near field of the plasma tube/Phanotron.

For more details, please check the link:
https://www.spooky2.com/forums/viewtopic.php?f=34&t=9820