The tuning PCB was designed because it is not possible to see the tuning light. You can turn the unit round to see the LED, but return it to the normal position during use. The tuning point will be almost the same.
Articles in this section
- How can I test if Spooky2 Scalar is working?
- Can anyone tell me what is the ideal tuning frequency?
- If the button on the receiver was off during a bfb scan and during a rife treatment (but the transmitter had been tuned) does that mean nothing happened?
- I find that the brightness of the tuning light on the Receiver is very sensitive to the lid angle.
- Why can we still tune scalar when we don’t connect the transmitter and receiver with link cable?
- I turn on Scalar, I turn the knob counter clockwise until the light is at it’s brightest. I’m at 5.6 then I turn the knob counter clockwise until the light goes off? I’m at 2.0 now? Is this correct?
- What happens when Scalar is turned on and not tuned? Does it reset to 8.0 Mhz during a power outage? Is it pumping out dangerous levels of EMF radiation?
- When should I worry about tuning point?
- I used two different tuning methods, using method one produced 6.10MHz, using method two produced 5.65Mhz. How do I know which one is most accurate?
- Can computers be in the Scalar field? Do you have to retune it at some point other than when you move it to a different position?
Comments
Please sign in to leave a comment.