Why there is no light showing on the receiver when I tried my 60 ft link cable using Scalar?

If you have no light, you have to tune it. Can’t use the old frequency you were using when it was closer. You will probably find your tuning points to be in the 4 MHz range, with the EMF point in the high 3 MHz range. The two points will be closer together, so you will need to ensure that you tune to the higher frequency and then double-check that it is indeed scalar not EMF. In fact, once the light on the tuning test coil lights, it may not go out between the two tuning points. To test if it is indeed scalar and not EMF-based tuning when you turn the test light on the receiver on, when you put your hand in front of the lid the light should not waiver. If it dims, you have an EMF-based tune.

Currently, mine is tuned to 4.35 MHz to achieve a 75 ft run through the entire house, metal pipes, bed frame and all. In the summer, it may tune as high as 4.75 MHz, I recheck the tune every so often as conditions can change over time.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/permalink/867618760478350/

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

See more
Register your product
You can get support that’s tailored to you, owner exclusives and more
Our helpline hours:
8:00am - 8:00pm CST Monday to Friday; 9:00am - 6:00pm CST Saturday
Follow us on Twitter
Get the latest news and updates first